Rear Caliper Won't Fit Over New Pads on a CFMoto U10?

Rear Caliper Won't Fit Over New Pads on a CFMoto U10?

If the rear caliper won't slide over new pads on your CFMoto U10 PRO, U10 XL PRO or Highland, the brake piston isn't retracted far enough. 

Why it happens

The U10's rear calipers have an electronic parking brake, and releasing it only backs the piston off a little. Our rear pads are thicker than stock on purpose (the caliper has room for it, and it adds pad life), so the piston needs to go all the way back. Don't force the caliper on.

How to retract the piston

Put the parking brake in maintenance mode: Per the CFMoto service manual: with the machine powered on, stopped, in Park and the parking brake on, press and hold the top of the parking brake switch (OFF) for 10–15 seconds, release it, then press OFF again within 3 seconds. You'll hear the rear motors run; that's normal.

No luck with maintenance mode: Start the machine and put it in gear and disengaging e-brake. Quickly disconnect the negative terminal on the battery and shut off machine (this keeps the piston from setting the e-brake after a 10min timer if you leave in neutral it will eventually set while you might have apart and damage the caliper). Disassemble rear brakes and calipers. Remove the two screws holding the electronic solenoid onto the caliper, and you can turn the piston in with some pliers gently where the motor turns the piston. Piston will go in further than just disengaging it, which allows the pads to slide right in and onto the rotor.

Don't skip this. If the parking brake sets while a caliper is off, it can push the piston right out of the caliper.

Leave the factory shims off.

Our ceramic pads don't need them, and they take up room the thicker pad needs. 

Finish with bedding

Bed the new pads with our bedding guide for your pad type. Properly bedding the pads ensures that the brakes perform their best. 

Back to blog